CONPATCH-
EM
THREE PARTS READY TO USE EPOXY MORTAR
Introduction
Conpatch
EM is general-purpose epoxy mortar supplied in three components
i.e Base Hardner & Aggregates in a pre weighed quantities. The
product is designed to meet the requirement of high early &
ultimate strength with properties of impact load resistance, abrasion
resistance & resistance to mild solvents & acids.
The
three-component ready to use pack consists of 8 kg in total.
AREAS
OF USAGE:
1. It can be used for structural crack repair in R.C.C elements
& repairs for places of load bearing importance.
2. General repair of damaged concrete, spalled concrete.
3. It is an excellent product for patching concrete floors where
heavy traffic movements are seen with impact load. It is a
proven product for repairs of dams, concrete roads, bridges &
runways.
4. Patching & repairs of precast elements & leveling mortar
for floors.
APPLICABLE STANDARD: In confirmation with IS: 9197. Test
confirmations as per IS 9162. ASTM C 818 II
PHYSICAL
PROPERTIES:
· Pot Life: About 50 to 60 minutes at 30°C
· Bond capacity: 6N/mm2, bond with concrete surface previously
primed with Conbond EP.
· Compressive strength: 80N/mm2at 7 days. Standard
lab result.
· Flexural strength: 20N/mm2 standard lab result.
· Tensile Strength: 20N/mm2 standard lab result.
· Pot Life after mixing: 45 to 60 minutes at 30°C depending
on humidity & wind viscosity also.
· Application temperature: 5° to 45°C, however for
good avoided during afternoon in summers.
· In service: -20°C to 60°C
.
|